Juniper SRX4100 - Chapter 14 Performing the Initial Configuration; Performing the Initial Configuration; SRX4100 Services Gateway Software Configuration Overview; SRX4100 Services Gateway Factory-Default Settings

CHAPTER 14
Performing the Initial Configuration
•
SRX4100 Services Gateway Software Configuration Overview on page 53
•
SRX4100 Services Gateway Factory-Default Settings on page 53
•
Viewing Factory-Default Settings on page 54
•
Configuring the SRX4100 Services Gateway on page 54
SRX4100 Services Gateway Software Configuration Overview
The services gateway is shipped with Junos OS preinstalled and ready to be configured
when the services gateway is powered on. If you are setting up the services gateway for
the first time, use the CLI to perform the initial configuration.
Related
Documentation
SRX4100 Services Gateway Factory-Default Settings on page 53•
• Viewing Factory-Default Settings on page 54
• Configuring the SRX4100 Services Gateway on page 54
SRX4100 Services Gateway Factory-Default Settings
Your services gateway comes configured with a factory-default configuration.
Table 24 on page 53 and Table 25 on page 53 lists the factory-default settings.
Table 24: Factory-Default Settings - Interfaces
IP AddressInterface
192.168.1.1/24fxp0
Table 25: Factory-Default Settings - Services
Services
SSH
HTTPS
53Copyright © 2017, Juniper Networks, Inc.