Juniper SRX4100 - Gateway; Table 22: Console Port Connector Pinout Information

Related
Documentation
Console Port Connector Pinout Information for an SRX4100 Services Gateway on
page 36
•
Console Port Connector Pinout Information for an SRX4100 Services Gateway
The console port is an RS-232 serial interface that uses an RJ-45 connector to connect
to a console management device. The default baud rate for the console port is 9600
baud.
Table 22 on page 36 provides the pinout information for the RJ-45 console connector.
An Ethernet cable that has an RJ-45 connector at either end and an RJ-45 to DB-9 serial
port adapter are supplied with the services gateway.
Table 22: Console Port Connector Pinout Information
DescriptionSignalPin
Request to SendRTS1
Data Terminal ReadyDTR2
Transmit DataTXD3
Signal GroundGround4
Signal GroundGround5
Receive DataRXD6
Data Set ReadyDSR/DCD7
Clear to SendCTS8
Related
Documentation
• Management Port Connector Pinout Information for an SRX4100 Services Gateway
on page 35
Copyright © 2017, Juniper Networks, Inc.36
SRX4100 Services Gateway Hardware Guide