Table 25: Factory-Default Settings - Services (continued)
Services
NETCONF over SSH
Related
Documentation
Viewing Factory-Default Settings on page 54•
• Configuring the SRX4100 Services Gateway on page 54
Viewing Factory-Default Settings
To view the factory-default settings on your services gateway:
1. Log in as the root user and provide your credentials.
2. View the list of default config files:
user@host>file list /etc/config
3. View the required default config file.
user@host> file show /etc/config/<config file name>
When you commit changes to the configuration, a new configuration file is created, which
becomes the active configuration. If the current active configuration fails, you can use
the load factory-default command to revert to the factory-default configuration.
Related
Documentation
SRX4200 Services Gateway Factory-Default Settings•
• Configuring the SRX4200 Services Gateway
• SRX4100 Services Gateway Factory-Default Settings on page 53
• Configuring the SRX4100 Services Gateway on page 54
Configuring the SRX4100 Services Gateway
This procedure explains how you can create an initial configuration using CLI commands
to connect the services gateway to the network.
NOTE: Before you can use J-Web to configure your services gateway, you
must access the CLI to configure the root authentication.
Copyright © 2017, Juniper Networks, Inc.54
SRX4100 Services Gateway Hardware Guide
To Next Page
Loading...
