To mount the services gateway in a four-post rack:
1. Attach the mounting ears to the front of the chassis, using the screws provided. Then,
attach the fixed brackets to the rear of the device, using the screws provided.
Figure 13: Attaching the Mounting Ears and Fixed Brackets
NOTE: Ensure that the rear of the device is supported throughout the
process of mounting the device into the rack.
2. Slide the device into the rack, and secure the mounting ears to the rack, using the
screws provided..
Figure 14: Securing the Mounting Ears to the Rack
3. Slide the adjustable brackets into the fixed brackets attached to the rear of the device.
43Copyright © 2017, Juniper Networks, Inc.
Chapter 10: Installing the Services Gateway
To Next Page
Loading...
