Installing the SRX4100 Services Gateway in a Rack
You can mount the services gateway on four posts in a 19-in. rack or cabinet by using the
rack-mount kit shipped with the device. (The remainder of this topic uses rack to mean
rack or cabinet.)
Before mounting the device on four posts in a rack:
1. Verify that the site meets the requirements described in “Site Preparation Checklist
for the SRX4100 Services Gateway” on page 22.
2. Place the rack or cabinet in its permanent location, allowing adequate clearance for
airflow and maintenance, and secure it to the building structure.
3. Verify that the rack or cabinet meets the specific requirements described in “SRX4100
Services Gateway Rack Requirements” on page 23 and “Cabinet Requirements for
SRX4100 Services Gateways” on page 24.
4. Remove the services gateway from the shipping carton (see “Unpacking the SRX4100
Services Gateway” on page 39).
Ensure that you have the following parts and tools available:
•
Phillips (+) screwdriver, number 2
•
Mounting screws (provided with the rack mount kit)
NOTE:
•
Installing the device in a rack requires two people: one person lifts the
device while the other secures it to the rack.
•
If you are installing multiple devices in one rack, install the lowest one first
and proceed upward in the rack.
Copyright © 2017, Juniper Networks, Inc.42
SRX4100 Services Gateway Hardware Guide
To Next Page
Loading...
