•
Metal plenum mounting bracket—see “Installing the WLA532E Access Point Using the
Plenum Bracket Kit” on page 51.
•
North America single gang wall box adapter—see “Installing the WLA532E Access
Point on the Wall Using the WLA-GNGWLBX-ADP-NA Wall-Mount Kit” on page 72.
•
EU single gang wall box adapter—see “Installing the WLA532E Access Point on the
Wall Using the WLA-GNGWLBX-ADP-EU Wall-Mount Kit” on page 70.
Software and Hardware Used with the Access Point
Use the following software (from Juniper Networks) to configure and operate the access
point:
•
RingMaster GUI—RingMaster to configure and monitor the access point
•
Mobility System Software (MSS) CLI—MSS to configure the access point.
For more information, see the RingMaster and MSS guides at: RingMaster and MSSGuides.
Use the following hardware from Juniper Networks to connect the access point and make
it operational:
•
WLC2 Wireless LAN Controller
•
WLC200 Wireless LAN Controller
•
WLC216 Wireless LAN Controller
•
WLC8 Wireless LAN Controller
•
WLC800R Wireless LAN Controller
•
WLC880R Wireless LAN Controller
•
WLC2800 Wireless LAN Controller
The WLA532E access point can be powered up and operational within 3 minutes and
supports all features of RingMaster and Mobility System Software (MSS).
Related
Documentation
WLA532E Antenna Models on page 7•
• External Antenna Configurations for the WLA532E Access Point on page 8
Copyright © 2012, Juniper Networks, Inc.6
WLA532E Access Point Hardware Documentation
To Next Page
Loading...
Need help?
General
