Juniper WLA Series User Manual

CHAPTER 8
Verifying the Health of the Access Point
•
Verifying the Health of WLA Series Access Points Using LEDs on page 77
Verifying the Health of WLA Series Access Points Using LEDs
After you install the WLA Series access point and enable the Power over Ethernet (PoE)
on the Ethernet cable connected to the access point, you can verify the access point
status by observing the health LED. The health or STAT LED indicates whether the access
point is operational.
•
If the LED is green and glowing steadily, the access point has been successfully booted
by the wireless LAN controller (WLC) and is operational.
•
If the LED is not steadily glowing green and is either yellow or alternating between
yellow and green, contact the system administrator for the WLC.
Related
Documentation
• Status LEDs on a WLA532E Access Point on page 8
77Copyright © 2012, Juniper Networks, Inc.

Juniper WLA Series Specifications

General

Brand	Juniper
Model	WLA Series
Category	Wireless Access Point
Language	English