This topic covers installation of the WLA532E access point on the European Faceplate
Standard Hardware WLA-GNGWLBX-ADP-NA kit. The faceplate is meant to be installed
onto an existing wall outlet box.
Ensure that you have the following parts and tools available to install the access point:
•
NA -standard faceplate – (provided in the WLA-GNGWLBX-ADP-NA kit)
The NA faceplate included in the kit covers the wall box and cables and has a minimum
extension plastic body that is meant to conform to the NA faceplate standard (see
Figure 41 on page 73).
Figure 41: NA Wall-Mount Bracket Dimensions
•
Two 6-32 flat-head, flat-tip screws (provided in the WLA-GNGWLBX-ADP-NA kit)
•
Flat-head screwdriver (not provided)
•
Category 5 cable, installed (not provided)
•
Two M3 or 6-32 wall anchors (not provided)
•
Wall-mount template (part number 530-043682, provided in the WLA-BRKT-WALL
kit)
•
(Optional) Security kit, which includes a security tool and a security screw (The kit is
not provided; you can order it separately at
https://www.juniper.net/customers/support/.)
73Copyright © 2012, Juniper Networks, Inc.
Chapter 7: Installing and Connecting the Access Point
To Next Page
Loading...
