Juniper WLA Series User Manual

• Installing the WLA532E Access Point on the Wall Using the WLA-BRKT-WALL
Wall-Mount Kit on page 64
• Installing the WLA532E Access Point on the Wall Using the WLA-GNGWLBX-ADP-EU
Wall-Mount Kit on page 70
• Installing the WLA532E Access Point on the Wall Using the WLA-GNGWLBX-ADP-NA
Wall-Mount Kit on page 72
Installing the WLA532E Access Point on a Ceiling Rail Using the Trapeze Legacy
Mounting Bracket Adapter Kit
If you have a ceiling-mounted Juniper Networks WLA522 Wireless LAN Access Point
installed on a suspended ceiling rail you can use the installed WLA522 universal mounting
bracket and a legacy mounting bracket adapter to install a WLA532E.
Mounting the device on the ceiling is the primary installation method and ceiling-mount
installation steps are provided in this topic. You can also install the WLA532E on a junction
box using a junction box wall-mount kit that can be ordered separately and installed
using the wall-mounting instructions in the Wireless LAN Services (WLS) documentation
at http://www.juniper.net/techpubs/ . Details about installation kits and other WLA
hardware information can be viewed on the WLA Series Wireless LAN Access Points data
sheet from the WLA Series Wireless LAN Access Points product page and the hardware
can be purchased by contacting a Juniper Partner or a Juniper Salesperson at
1-866-298-6428.
This WLA532E ceiling mount kit includes a legacy mounting bracket adapter for mounting
the access point to a recessed, 9/16-inch or 15/16-inch T ceiling-tile rail in a location
where a WLA522 is already installed.
Before installing the WLA532E on the ceiling using a legacy mounting adapter bracket
adapter:
•
Locate an installed WLA522 on a suspended ceiling rail.
•
Read “General Safety Guidelines and Warnings” on page 23.
•
Remove the access point and the legacy mounting bracket adapter from the shipping
carton (see “Unpacking a WLA532E Access Point” on page 44).
Ensure that you have the following parts and tools available to install the access point:
•
One legacy mounting bracket adapter (provided)
•
One ceiling-mount bracket (WLA-BRKT-CLNG) (provided)
•
Category 5e straight-through signaling cable with RJ-45 connectors, installed (not
provided)
57Copyright © 2012, Juniper Networks, Inc.
Chapter 7: Installing and Connecting the Access Point

Juniper WLA Series Specifications

General

Brand	Juniper
Model	WLA Series
Category	Wireless Access Point
Language	English