Juniper WLA Series User Manual

Table 5: LED Status and Description of WLA532E
Status and DescriptionColorLabel
No powerOffSTAT
Indicates
access point
status and
power
On. The AP is on power on self-test mode.Flash amber
On. The AP is waiting to receive boot instructions and a configuration file
from a WLC.
Flash green
On. The AP is booting and receiving a configuration file from the WLC. After
the AP boots and receives a configuration, this alternating LED appearance
persists until a radio is enabled.
Flash Green or Amber
On. Powered on and the AP is operational.Green
On. The AP has failed to configure and is not operational.Red
On.. The 2.4GHz Radio is disabled.AmberLED 11BGN
Indicates radio
status and
activity on the
2.4GHz radio.
On. The 2.4GHz Radio is enabled.Green
On. Dedicated sensorAmber
On. The Unit is transmitting/receiving on 2.4GHz radioFlashing Green
On. Radio failed.Red
On. The 5GHz Radio is disabled.AmberLED 11AN
Indicates radio
status and
activity on the
5GHz radio.
On. The 5GHz Radio is enabled.Green
On. Dedicated sensorAmber
On. The Unit is transmitting/receiving on 5GHz radioFlashing Green
On. Radio failed.Red
Related
Documentation
Verifying the Health of WLA Series Access Points Using LEDs on page 77•
MAC Address Information for WLA Series Access Points
Each WLA Series access point is assigned a unique block of 64 MAC addresses. Each
radio has 32 MAC addresses and supports up to 32 service set identifiers (SSIDs), with
one MAC address assigned to each SSID as a basic service set identification (BSSID).
The access point MAC address block is listed on a label on the back of the access point.
9Copyright © 2012, Juniper Networks, Inc.
Chapter 1: WLA532E Access Point Overview

Juniper WLA Series Specifications

General

Brand	Juniper
Model	WLA Series
Category	Wireless Access Point
Language	English