• Installing the WLA532E Access Point on the Wall Using the WLA-BRKT-WALL
Wall-Mount Kit on page 64
• Installing the WLA532E Access Point on the Wall Using the WLA-GNGWLBX-ADP-EU
Wall-Mount Kit on page 70
• Installing the WLA532E Access Point on a Ceiling Rail Using the Trapeze Legacy
Mounting Bracket Adapter Kit on page 57
Connecting the Access Point to Wireless LAN Controllers
After you install the wireless LAN access point, you can connect it to a wireless LAN
controller (WLC) directly or indirectly through an intermediate Layer 2 or Layer 3 network.
To connect the access point directly to a controller or switch:
1. Insert one end of the installed Category 5 cable with a standard RJ-45 connector in
the Ethernet port of the access point and the other end in Ethernet port of the
controller.
2. Look at the access point STAT LED for the port on the controller and verify that the
link is activated.
The link is activated if the STAT LED is green and glowing steadily.
To configure the access point connection, use the RingMaster GUI or the Mobility System
Software CLI.
If you are installing the access point in a wireless LAN mesh or wireless bridge
configuration, you must configure the access point before deploying the access point in
the final location. For more information, see the Mobility System Software Configuration
Guide from the Software Documentation section at Wireless LAN Services (WLS)
documentation .
Related
Documentation
• Status LEDs on a WLA532E Access Point on page 8
Copyright © 2012, Juniper Networks, Inc.76
WLA532E Access Point Hardware Documentation
To Next Page
Loading...
Need help?
General
