o
Server
For
setting the server name (“mystation.com”, etc.)
or the IP address (“192.168.0.1”, etc.) of the FTP
server.
* Enter not more than 127 characters using
single-byte alphanumeric characters (a to z, 0 to
9), single-byte hyphen [-], or dot [.].
o
Port
Enter the FTP server port number to use using an
integer between 1 and 65535.
The default value varies with the protocol setting.
(FTP: 21, SFTP: 22, FTPS: 990, FTPES: 21, ZIXI:
2088)
o
Dir. Path
Enter the path name for the directory to upload to
(“/pub”, “/home/user
”, etc.)
* Enter not more than 127 characters.
o
Username
Enter the user name for connecting to the FTP
server.
*
Enter not more than 31 characters.
o
Stream ID A
For configuring the stream ID that is registered at
the distribution destination.
The default value varies with the product model.
*
Enter not more than 63 characters.
Memo :
0
This
item is selectable only when [Type] is set to
“ZIXI”.
o
Password
Enter the password for connecting to the FTP
server.
*
Enter not more than 31 characters. Enter not
more than 127 characters for ZIXI setting.
o
PASV Mode
For setting whether to set the communication mode
used for file transfer to the passive mode.
Set to
“On” if the camera is inside a firewall, and a
connection from the FTP server to the camera
cannot be established.
[Setting Values: On, ROff]
Memo :
0
When [
Protocol] is configured to “SFTP” or
“ZIXI”, this item appears as “---” and cannot be
selected.
150
Network Menu
Menu Display and Detailed Settings
To Next Page
Loading...
Need help?
General
