➤ Make sure all covers and safety guards are in place and secured before re-starting.
Temperature
➤ Do not touch hot components!
These include, for example, compressor blocks, compressed air lines, coolers, motors and ma‐
chine heaters.
➤ Wear protective clothing.
➤ If welding is carried out on or near the machine, take adequate measures to prevent sparks or
heat from igniting oil vapours or parts of the machine.
Noise
➤ Operate the machine only with intact sound insulation.
➤ Use hearing protection when appropriate.
The pressure relief valve blowing off can be particularly loud.
Operating fluids/materials
➤ Strictly forbid fire, open flame and smoking.
➤ Follow safety regulations when dealing with oils, lubricants and chemical substances.
➤ Avoid contact with skin and eyes.
➤ Do not inhale oil mist and vapours.
➤ Do not eat or drink while handling cooling and lubricating fluids.
➤ Keep suitable fire extinguishing agents ready for use.
➤ Use only KAESER approved operating materials.
Unsuitable spare parts
➤ Use only spare parts approved by the manufacturer for use in this machine.
Unsuitable spare parts compromise the safety of the machine.
➤ Use only genuine KAESER replacement parts on pressure bearing parts.
Conversion or modification of the machine
➤ Do not permit conversion or modification of the machine as this can compromise function and
safe working.
Extending or modifying the compressor station
➤ If a compressor station is to be extended or changed,
check the blow-off capacity of the pressure relief valves on air receivers and pipework before
installing the new devices.
➤ Pressure relief valves of insufficient blow off capacity
must be replaced by valves with a higher capacity.
3.5.2 Safe machine operation
Information on safe conduct when handling the machine is found here.
3 Safety and Responsibility
3.5 Dangers
16
Service Manual 2-stage piston compressor
EPC No.: 9_9431_02 E
To Next Page
Loading...
Need help?
General
