KAESER EPC Series User Manual

Fault Possible cause Remedy
Machine uses too much oil. Viscosity too low. Fill with oil specified in the ser‐
vice manual.
Crankcase venting defective. Clean or renew the crankcase
vent.
Piston rings worn or broken. Contact KAESER service.
Piston rings already worn or
damaged after only a short op‐
erating period.
Dirty oil. Fit finer air inlet filter.
Tab. 30 Faults and remedies
9 Fault Recognition and Rectification
9.2 Alarms
No.: 9_9431_02 E
Service Manual 2-stage piston compressor
EPC
45

KAESER EPC Series Specifications

General

Type	Rotary Screw Compressor
Drive Type	Direct Drive
Cooling System	Air-cooled
Control System	Sigma Control 2.0
Weight	Varies depending on model
Noise Level	62 - 75 dB(A) (depending on model)