13
3 Type overview
MULTICAL
®
The supplied meter is configured from the factory and ready for use, however it can also be changed/reconfigured
after installation.
402 can be ordered in many combinations as required by the customer. First you select the required
hardware from the type overview. Then select ”Prog”, ”Config” and ”Data” to suit the application in question.
Please note that the points marked “Total prog” cannot be changed without breaking the verification seal. This
means that the change must be carried out by an accredited meter laboratory.
We currently develop new functions and modules for MULTICAL
®
402. Please contact Kamstrup A/S if your
application is not covered by the variants shown.
3.1 Type and programming overview
Type number 402xxxxxxxxxx (Total prog)
Selection of Pt100/Pt500 calculator, modules, supply,
sensor set, flow sensor and language on label
Prog.
A-B-CCC
(Total prog
Forward/return – Energy unit – Flow meter code
)
Config. D
DD-EE-FF-GG-N-PP (Partial prog)
Display – Tariff – Pulse inputs
Leak sensibility – Pulse outputs
Data: (Partial prog.)
-Customer No.
-Target date
-Tariff limits
-Average peak time max./min.
-Heat/cooling switching
-Date/time
To Next Page
Loading...
