14.3.2 Time / date (Basic/Advanced Mode)
In this menu the built-in clock in the meter can be read out and adjusted either manually or by setting the meter
to the clock of the PC on which METERTOOL is running.
14.3.3 Modules (Advanced Mode)
The menu “Modules” is used for configuration of module data for modules mounted in the meter’s module
position . See paragraph 11.4 - Modules.
14.3.4 Preset VA / VB (Advanced Mode)
Presets the register values of the two extra pulse inputs for water and electricity meters.
14.3.5 Print Label (Advanced Mode)
Initiates printing of meter label. Reading of the meter configuration is required before printing can take place.
14.3.6 Verification (Advanced Mode)
See separate paragraph, 14.3 Verification with METERTOOL HCW.
14.3.7 Verification unit settings (Advanced Mode)
See separate paragraph, 14.3 Verification with METERTOOL HCW.
14.3.8 Verification unit calibration (Advanced Mode)
See separate paragraph, 14.3 Verification with METERTOOL HCW. Used for changing between temperature set
points during calibration.
14.3.9 Certificate (Advanced Mode)
Initiates printing of verification certificates.
14.3.10 Flow Curve Adjustment (Advanced Mode)
Please, see section 14.4.
To Next Page
Loading...
