ACD320 user manual Parameter Description
- 85-
F4.11 Fault auto-reset times 0～3 0
F4.12
Interval time setting of
automatic resetting fault
0.1～100.0s 1.0s
Fault auto-reset times: used to set the auto-reset times when inverter chooses fault auto-reset.
If this value is exceeded, inverterwill wait for trouble shooting.
Interval time setting of fault auto-reset: chose the interval time between fault occurring and
automatic resetting actuated.
Function Code Name Setting Range
Default
Value
F4.13 FDT level detection value 0.00～ F0.04 50.00Hz
F4.14 FDT delay detection value 0.0～100.0%(FDTlevel) 5.0%
Set output frequency detection value and the delay value of output action dismissed, as
shown by following figure:
Fig.6-16 FDT LevelDiagram
Function Code Name Setting Range
Default
Value
F4.15 Frequency reaching
detection range
0.0～100.0%(maximum
frequency)
0.0%
When the inverter output frequency reaches the set frequency value, this function can
regulate its detect ion range value, as shown by following figure:
To Next Page
Loading...