KBR multicomp D6 7 Series - Page 107

V7.00
24905_EDEBDA0272-5019-1_EN
107
Continued: Error messages
E25 No measuring current (for low load operation, the stag-
es are switched o after one hour)
Alarm relay
E26 Capacitor current too high (with induced current mea-
surement)
Alarm relay
E27 Check fuse (for induced current measurement, no cur-
rent increase due to connection of a stage)
Alarm relay
E28 Loss of capacitance Alarm relay
E29 Contactor defect
(current does not decrease when stage is switched o)
Alarm relay
E30 Stage locked due to induced current error Alarm relay
E31 Induced current limit violated
E33 Relay module 1 cannot be reached Alarm relay
E34 Relay module 2 cannot be reached Alarm relay
E35 Relay module 3 cannot be reached Alarm relay
E36 Relay module 4 cannot be reached Alarm relay
E37 Relay module 5 cannot be reached Alarm relay
E38 Temperature module 1 cannot be reached Alarm relay
E39 Temperature module 2 cannot be reached Alarm relay
E40 Temperature module 3 cannot be reached Alarm relay
E41 Temperature module 4 cannot be reached Alarm relay
E42 Temperature module 5 cannot be reached Alarm relay
E43 Induced current module 1 cannot be reached Alarm relay
E44 Induced current module 2 cannot be reached Alarm relay
E45 Induced current module 3 cannot be reached Alarm relay
E46 Induced current module 4 cannot be reached Alarm relay
E47 Induced current module 5 cannot be reached Alarm relay
E48 Induced current module 6 cannot be reached Alarm relay
System operation