KBR multicomp D6 7 Series - Page 108

V7.00
24905_EDEBDA0272-5019-1_EN
108
System operation
NOTE
Under the item Relay / stage switch-o , an action according to the preceding list
can be activated or deactivated when one of the error messages E17 to E48 is displayed.
For the error message E24 alarm temperature exceeded or short circuit on any tempera-
ture probe, or broken wire, an additional note is displayed in the main menu Temperature:
SC = Short circuit
BR = Broken wire
NA = Temperature measurement not activated
Message window => Rel.: Error message text: Error message, alarm relay and message
(ER+M), o (function deactivated).
When the Generator mode is active, the window “message outputs” is accessible in the
window “Info” via F3 (Outp.). Here, the dierent statuses of the controller about free relay
outputs can be displayed.
Mode Target CosPhi at DI => Phi:
PhiA, PhiB, PhiC, PhiD, Phi-default, aOn (all stages On), aO(all stages o)