V7.00
24905_EDEBDA0272-5019-1_EN
78
3. Cabinet No. 1 to 6
4. Discharge time 0 to 900 sec.
5. Detuning 0, 5.5, 7, 8, 12.5, 14%
6. Operating cycle reset
7. Overtemperature switch-o reset
8. System type standard, combination lter, special
9. Special outputs fans/alarm relays programmable for terminals K5 (45) and C/S (30, 31).
These outputs are by default assigned to fan and alarm relay, can however also be used as
capacitor stages.
NOTE
The alarm relay output is set as an NC contact by default, but can be reprogrammed as an
NO contact through visual energy in the stage conguration.
For a completely congured controller, the following window appears:
System operationSystem operation
To Next Page
Loading...
