V7.00
24905_EDEBDA0272-5019-1_EN
83
Description of the module scan:
Press the
() button to select the entry scan and start scanning by pressing
(SCAN).
As long as scan is ashing, you can set the rst module (and all subsequent modules to
be scanned) into scanning mode using the Scan button on the modules (see Appendix/
Additional modules). The module is then detected by the controller and allocated to the
relevant cabinet.
As soon as all additional modules are read, the scanning mode is to be stopped by
pressing
. The list of modules can now be checked for completeness by pressing the
buttons
() and
N
(). The cabinet allocation can be changed with
(Para).
Display example after module scan:
System operationSystem operation
To Next Page
Loading...
