V7.00
24905_EDEBDA0272-5019-1_EN
96
Temperature measurement, incl. enabling:
Parameters
Temperature
measurement
= active / inactive
Switching
threshold fan
= 0 to 70°C / hysteresis = 0°C to 25°C
Operating point
alarm
= 0 to 70°C / hysteresis = 0°C to 25°C
Operating point
overtemperature
= 0 to 70°C / hysteresis = 0°C to 25°C
Return
Operating point and hysteresis fan relays
and overtemperature switch-o
Temperature parameters
P
N
Fans
Alarm
EDIT
Enabling / disabling
temperature measurement
Operating point and hysteresis alarm relays and
overtemperature switch-off
Menu description
Display hot-key area
NOTE
The set temperature operating points and hysteresis are equally valid for the controller
basic module and the additionally connected temperature module.
Moreover, limits are available for the overvoltage switch-o of the system, monitoring of
the operating cycles of the stage contactors, monitoring of the current consumption of
individual stages, monitoring of the current consumption of complete cabinets and the
switch-o of stages if voltage harmonics are too high.
The setting range of the overvoltage switch-o goes up to 150% of the measuring
System operation
To Next Page
Loading...
