232
LO - Output Parameters
Setting: Description: NUM
Cabinet Fan On
***
Output is set when the drive heatsink reaches 40
degrees Celsius
12
Condition 1 Output is linked to LO30-32.
13
NTSD Output Output activates when NTSD slowdown is triggered
and remains on until the direction is dropped or
until the command speed is below the TS02 NTSD
Target Speed (analog or serial speed control)..
14
HV On For use with Active Front End applications.
15
AFE Enable Used to enable an Active Front End drive.
16
Default (LO05) = At Speed (5)
Default (LO10) = Deceleration Active (7)
Default (LO15) = Off (0)
Default (LO20) = Drive On (4)
* Only one of these four conditions can be selected at a time.
*** Only one of these three conditions can be selected at a time.
To Next Page
Loading...
