KEB COMBIVERT F5 Reference Manual

331
Errata
(v3.33) Rev1B Corrections
Section 2.1.2: Specied to use manufacturer recommended tightening torque on
bolts when mounting drive.
Section 2.2.12: Added description of dielectric testing performed on all elevator
drives and provided recommended settings for testing with the integrated system.
Section 2.2.13: Added insulation measurement requirements.
Section 2.2.14: Added information on the new Brake Transistor Monitor Circuit.
Section 2.5: Added technical data for housings 16H and 17H and updated techni-
cal data for housing 23U.
Section 2.7: Updated power terminal images to display brake transistor Monitor
relays K1/K2.
Section 3.3.2: Maximum allowable EnDat cable length is now 110m.
Section 3.3.3: Updated erroneous wiring diagram.
Section 5.2.2: Added information about using the KEB Elevator app to program
and troubleshoot drive.
Section 5.3: Claried setup instructions directing technicians to contact OEM for a
controller parameter reference when programming drive.
Section 6.2: Claried description of parameter LI60.
Updated description and braking diagram for Emergency
Slowdown feature.
Section 6.6: Claried description of parameter LS04.
Section 6.11: Claried description of parameter LX15.
Claried description of parameter LX22.
Section 7.2: Added troubleshooting steps in the event that parameter
LM07 does not visibly change due to scaling.
Added troubleshooting steps to resolve ECdd errors.
Added troubleshooting steps to resolve EBus errors.
Added troubleshooting steps to resolve EEnC1 errors.
Section 7.3: Added troubleshooting steps to resolve encoder slippage
problems.
Added troubleshooting steps to resolve issues where the
brake makes “clunk” noise after a run.
Added troubleshooting steps to resolve glitchy keypad issues.
(v3.33) Rev1A Corrections
Section 3: Corrected lter times to 10-100msec for X2A digital inputs.
Section 4.3: Updated backward compatibility info for v3.33.
Section 6.2: Added parameter LI04 (missing since v3.21 manual). Added parameter
LI60.
Section 6.6: Added information regarding the use of LI60.
Section 6.11: Updated LX02 Switching Frequency to include 4kHz operation.
Section 6.12: Updated CH03 - removed Restore From Card; changed to Load
Parameter List.
Section 3: Updated EnDat, SSI and Hiperface pinout tables to clarify Sin/Cos
information with respect to A/ B channels.
9. Errata

KEB COMBIVERT F5 Specifications

General

Category	DC Drives
Enclosure Rating	IP20
Control Mode	Vector Control, V/f Control
Protection	Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short circuit
Fieldbus Communication	PROFIBUS, CANopen
Communication Interfaces	RS-485
Input Voltage	380-480V AC
Cooling Method	Forced air cooling (fan)