KEB COMBIVERT F5 Reference Manual

261
TS - Terminal Slowdown Parameters
Overview
The terminal slowdown parameters congure the settings for inputs assigned
as Normal Terminal Slowdown (NTS) inputs. (LI04-11).
The purpose of the NTS inputs is to provide an expedited and/or an alternate
slowdown means when the elevator speed approaching a terminal landing is
greater than a dened level. If this level is exceeded, the drive will perform
an NTS stop; otherwise, the drive will continue as normal.
Up to three NTS speed thresholds in each direction can be set with each input
corresponding to an NTS speed threshold or two inputs can be binary-coded
(TS01 NTSD Mode). This provides multiple checks during slowdown as the
contract speed increases.
Speed
LS02
TS02
Direction
Dropped
NTSD 1
Speed
NTSD 2
Speed
NTSD 3
Speed
6.17 TS - Terminal Slowdown Parameters

KEB COMBIVERT F5 Specifications

General

Category	DC Drives
Enclosure Rating	IP20
Control Mode	Vector Control, V/f Control
Protection	Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short circuit
Fieldbus Communication	PROFIBUS, CANopen
Communication Interfaces	RS-485
Input Voltage	380-480V AC
Cooling Method	Forced air cooling (fan)