Enter the following input parameters (Home > Prog > Inputs) depending on
the controller requirements.
• LI01 - Type of Input (PNP or NPN logic)
• LI04-11 - Input Function
SETUP OF THE INPUTS IS NOW COMPLETE!
Enter the following output parameters (Home > Prog > Outputs) depending
on the controller requirements.
• LO05 - Output Function O1
• LO10 - Ouput Function O2
• LO15 - Output Function RLY1
• LO20 - Output Function RLY2
SETUP OF THE OUTPUTS IS NOW COMPLETE!
5.4.1 Inputs
5.4.2 Ouputs
Initial Startup
94
To Next Page
Loading...
