7
General
Section 2.2.4.1: Removed the column which refers to the UL 489 MCCB.
Section 2.2.4.2: Removed the column which refers to the UL 489 MCCB.
Section 2.4: The rated output current has been changed to 224A. The
E.OC trip level is 540A.
Section 2.6: The Shallow version of the heatsink is only used on 230V size
19 R housing. Previously this was described as “Peak Unit.”
Section 2.10: Reworded “Error Low Speed Overload” to “Error Overload
Low Speed” in the Table of Contents, in LX07 (Pg. 210), and in Diagnostics
and Troubleshooting (Pg. 275 and 286) to better allign the manual to what
displays on the LCD screen.
Section 6.2: The Binary Speed Selection information for parameter LI16
has been updated to display the correct control inputs for both S
High
and S
Correction
sections of the table.
Section 6.4: LE - Encoder Data Parameters LE37 - LE39 added with pa-
rameter descriptions
Section 6.6: The LS01 upper limit has been increased from 25FPM to
59FPM. The upper limit can only be increased when LX50 Unlock LS01 is
activated.
Section 6.6: The ETS/ESD Speed Diagram in LS49 has been updated
Section 6.8: LC32 - The torque boost default setting has been updated
from 0.5% to 5%.
Section 6.11: The LX35, Improved Phase Detection, has been added.
Section 6.11: The LX50, Unlock LS01, has been added.
Section 6.12: CH01 Default Parameters - The option “Pi Password” (2) has
been added so that the keypad can be completely defaulted.
Section 6.16: Changed DG19 Pre-torque value from 0 to 1.
Section 6.16: Added DG50 Elevator Speed parameter.
Section 6.16: DG80 Easy Direction and Digital Output Status has been
added
Section 6.18: The DB (Debug Parameter Group) section has been added
1.2 Summary of Changes
To Next Page
Loading...
Need help?
General
