Need help?Do you have a question about the Keba ServoOne Series and is the answer not in the manual?
General| Protection Class | IP20 |
|---|---|
| Cooling Method | Forced air cooling |
| Communication Interface | Ethernet |
| Ambient Temperature | 0 to 45 °C |
| Storage Temperature | -20 to 70 °C |
| Relative Humidity | 5 to 95% (non-condensing) |
Guidelines for safe installation, operation, and handling of KEBA devices, including electrical hazards.
Detailed safety warnings regarding electrical power, hot surfaces, electrostatic discharge, and rotating parts.
Defines the purpose of the devices as components for stationary electrical systems and compliance with directives.
Specifies the intended use of the ServoOne supply unit within a multi-axis system.
Outlines the responsibilities of installers and operators for machine safety and risk assessment.
Instructions and dimensions for mounting supply units in wall mounting housing variants.
Instructions and dimensions for mounting supply units in liquid cooling housing variants.
Crucial warnings and safety instructions to be observed before and during electrical installation.
Guidelines for effective EMC installation, including cable type, routing, shielding, and earthing measures.
Procedures for connecting mains supply, protective earth, DC power supply, and controlling on/off.
Procedures for connecting control supply voltages and mains supply, including precharging and synchronisation.
Information and instructions for connecting the braking resistor, including safety warnings.
Important notes and warnings for operating the device safely and preventing damage.
Step-by-step guide for initial commissioning, including wiring, voltage setup, parameter configuration, and switching on.
Explanation of device states, error indications, and how to interpret error codes and descriptions.
To Next Page
