Keba ServoOne Series - 5.4 Integrated Control Unit Functions

Operation Manual ServoOne Supply Unit
66
ID no.: 1101.21B.6-00 Date:04/2020
The following functions and displays are available:
y Indication of the device status (see chap.6.1, p.71)
The device status is indicated after switching on the control supply. If no input
is made via the keypad for 60seconds, the display switches back to the
indication of the device status.
y Indication of the device error status (see chap.6.1.1, p.71)
On the occurrence of an error in the device, the display is immediately switched
to the indication of the error code.
y Parameter setting (indication "PA") (see chap.5.4.3, p.68)
Resetting device parameters to their factory setting
y Ethernet IP address setting (indication "IP") (see chap.5.4.4, p.68)
Ethernet IP address and subnet mask setting
y Field bus settings (indication "Fb") (see chap.5.4.5, p.69)
E.g. eld bus address setting
5.4 Integrated control unit
The integrated control unit permits diagnostics on the drive controller. . The control unit
comprises the following elements, all located on the front of the device:
y 2-digit 7-segment display (D1, D2)
y Two buttons (T1, T2)
D1
D2
T2
T1
Figure 5.7 Integrated control unit
Commissioning