Keba ServoOne Series - Field Bus Address Menu (Fb)

Operation Manual ServoOne Supply Unit
69
ID no.: 1101.21B.6-00 Date:04/2020
NOTE:
y During the ashing phase after step7 the save procedure can still be
aborted by pressing any button, without applying the value set. Otherwise
the new value will be saved after ve seconds.
y The modied IP address is only effective after restarting the control
electronics (24-V reset).
5.4.5 Field bus address menu (Fb)
The functions available on this menu item depend on the device's communication
option. For detailed information refer to the relevant specication.
Menu level Pa-
rame-
ter
Value
range
Meaning Explanation
1 2
Fb Ad -
00..xx
or
- -
Field bus
address
Setting for eld bus address (only if eld bus
option used), otherwise indication "- -"
(The maximum value that can be programmed
depends on the option)
Po -
0..3
or
- -
Transmit
power
Setting for bre-optic power output
(only with SERCOS II option), otherwise display
"- -"
Table 5.10 Field bus address menu
Example conguration of the subnet mask
In this example the subnet mask is changed from 255.255.255.0 to 122.255.255.0.
T1
T2
Tx
Tx
back
back
back
several actuations
of buttonTx (X = 1, 2)
until the desired menu
appears in the display
single actuation
of button Tx (X = 1, 2)
simultaneous actuation
of both buttons T1 and T2
Actuation of
any button
accept
>5 s>5 s
<5 s
T2
<5 s
T1 T2
T1 T2
T1 T2
back
T1 T2
back
T1 T2
T1 T2
T1 T2
T1 T2
Value NOT
saved
Value
saved
T1
T2
T1
T1
back
T1 T2
T2
Figure 5.8 Example conguration of the subnet mask
Commissioning