Identification of motorcycle
1. Frame number ① labeled as: *LBBK6910?????????*, as shown
in Figure 1-1.
Figure 1-1
2. Frame nameplate is riveted at frame Position ②, as shown in Figure 1-1. Words on the nameplate are as described
in Figure 1-2.
Figure 1-2
3. Serial number of engine ① is marked on the housing of
crankcase, as shown in Figure 1-3.
Figure 1-3
Important Notice
1. Please use spare parts manufactured by KEEWAY Motorcycle Co., Ltd. Components that cannot comply with the
designed specifications of KEEWAY Motorcycle Co., Ltd. may result in damage of the engine.
2. Only metric tools can be used for maintenance work. Metric bolts, nuts and screws cannot be exchanged with inch
fasteners.
3. While re-assembling, new washers, O rings, cotter pins and locking plates shall be renewed.
4. While tightening bolt or nut, please first fasten bolts of large-diameter or internal bolts; and then tighten gradually
to the specified torque in diagonal order. Those with special requirements are excluded.
5. Clean the removed components with cleaning liquid. Lubricate all the sliding surfaces before assembly.
6. After assembly, check that all the components are correctly installed and operated.
7. Remove dirt and oil before measurement; apply recommended lubricant at lubricating positions at assembly.
8. When the engine and transmission system are disassembled/assembled and to be stored for a long time, please
apply some lubricant on the surface of the components to avoid rust and dust deposition.
To Next Page
Loading...
Need help?
General
