KEEWAY RKV125 - 16.4 Crankshaft Assembly Procedures

Remove screws, engine oil filter roller cover and its cover
washer.
Remove washer and location pin.
Use an electric or pneumatic tool to screw off locknut.
Remove oil filter roller and take down the drive gear.
Screw off engine oil pump screws and remove oil pump
assembly.
16.4 Crankshaft Connecting Rod Assembly
Removal
Remove left crankcase.
Remove washer and location pin.
Remove drive gear.
Remove the crankshaft connecting rod assembly from the right
crankcase.
* Attention: Please do not hurt washer and closing surface.
Release lever
assembly
Right cover
Washer
Cover of oil
filter roller
Drive chain
Locknut
Oil filter
roller
Oil pump
Location pin
Crankshaft connecting
rod assembly
Location pin
Washer
Drive gear