Ignition system -- perform maintenance inspection on obvious and continuous ignition malfunctions,
engine on fire, overheated back burning and others.
Carbon deposit removal -- obvious underpowered, get rid of carbon deposit at cylinder head, piston head
and air exhaust system.
Please go to your local KEEWAY Motorcycle dealer periodically for inspection and adjustment to keep your vehicle
in best conditions.
In above table, monthly 1000km travel is employed as reference.
I— Inspect A—Adjust R—Replace C—Clean L—Lubricate
Note: 1.“*” for items involved in exhaust gas, which meets regulations of China Environmental Protection Agency.
Normal maintenance shall be performed according to specifications on the user’s manual; unauthorized repair and
adjustment are forbidden. We will not be responsible for the results.
2. You shall clean more frequently the air cleaner to extend its service life when your motorcycle is used on
sand-gravel roads or in severely polluted environment.
3. More frequent servicing may be required when the motorcycle is often driven at high speed or travels a long
distance.
Engine Oil/Filter
Engine oil level
*Attention
• Motorcycle shall stand on the flat ground while checking engine oil
level.
•Inspect engine oil level when the engine has run for 2~3mintues or
stopped for 2~3minutes.
Check engine oil level
When the engine oil level sensor alarms, refill engine oil to its upper limit.
Engine oil replacement
* Attention
When the engine is warmed up, replace engine oil. The oil can flow
out easily.
Shut down engine.
Screw off the drain plug at the bottom of crankcase (1) to drain engine
oil.
To Next Page
Loading...
Need help?
General
