Install a new headlamp bulb (3).
Screw tightly the new bulb into the adapter.
Avoid touching bulb glass with your bare hands during
installation and staining it with oil, which may affect
transparency, service life and luminous flux of bulb.
If oil is adhered to the bulb, clean it with a cloth moistened
with alcohol or highly volatile rubber solution.
Install headlamp assembly.
Clutch
Check clearance of clutch cable.
Clearance: 10-15mm.
Adjust clearance of clutch cable.
First loosen lock nut (1).
Screw in or screw off adjuster (2) till clearance meets the
specified value.
Finally tighten the locknut.
To Next Page
Loading...
