3: Using a remote interface DAQ6510 Data Acquisition / Multimeter System
3-8 DAQ6510-900-01Rev. A / April 2018
Figure 20: Name Virtual Instrument dialog box
9. In the Virtual Instrument Name box, enter a name that you want to use to refer to the instrument.
10. Select Finish.
11. Select Cancel to close the Wizard.
12. Save the configuration. From the Keithley Configuration Panel, select File > Save.
Verify the instrument through the Keithley Communicator:
1. Click Start > Keithley Instruments > Keithley Communicator.
2. Select File > Open Instrument to open the instrument you just named.
Figure 21: Keithley Communicator Open an Instrument
3. Click OK.
4. Send a command to the instrument and see if it responds.
To Next Page
Loading...
