Kenwood eXcelon KDC-X991 User Manual

English
|
23
In Standby mode
Display Type E
G-Analyzer vehicle weight setup
Enter vehicle weight to calculate horsepower.
1 Enter G-Analyzer vehicle weight setup mode
Using the Control knob, select "DISPLAY" >
"GMA" > "GAUGE" > "WEIGHT".
For the operation method, refer to <Function
Control mode> (page 11).
"WEIGHT INPUT" is displayed.
2 Select the weight numbers
Turn the Control knob.
⁄
• The weight input range is between 1000-9999 lbs.
3 Select the digits to enter
Push the Control knob towards right or left.
4 Repeat steps 2 and 3, and complete the weight
input.
5 Exit G-Analyzer vehicle weight setup mode
Press the Control knob.
In Standby mode
Display Type E
G-Analyzer vehicle class setup
Enter vehicle class to calculate horsepower.
1 Enter G-Analyzer vehicle class setup mode
Using the Control knob, select "DISPLAY" >
"GMA" > "GAUGE" > "CLASS".
For the operation method, refer to <Function
Control mode> (page 11).
"CLASS SELECT" is displayed.
2 Select vehicle class
Turn the Control knob.
Each time you push the knob, the vehicle class
alternates between the modes shown in the table
below.
Display
"Mid Size"
"Full Size"
"SUV"
"Van/ Mini-Van"
"Pickup Truck"
"Sporty"
"Compact"
3 Exit G-Analyzer vehicle class setup mode
Press the Control knob.
B64-3767-0000KEnglish.indd23B64-3767-0000KEnglish.indd23 07.5.102:15:49PM07.5.102:15:49PM

Kenwood eXcelon KDC-X991 Specifications

FM Tuner Section

frequency range	87.9 MHz – 107.9 MHz
usable sensitivity	9.3 dBf (0.8 μV/75 Ω)
quieting sensitivity	15.2 dBf (1.6 μV/75 Ω)
frequency response	30 Hz – 15 kHz
signal to noise ratio (MONO)	70 dB
selectivity	≥ 80 dB
stereo separation	40 dB

AM Tuner Section

frequency range	530 kHz – 1700 kHz
usable sensitivity	28 dBμ (25 μV)

CD Player Section

spindle speed	1000 – 400 rpm (CLV 2times)
frequency response	10 Hz – 20 kHz
total harmonic distortion	0.008 %
signal to noise ratio	110 dB
dynamic range	93 dB

USB Interface

usb standard	USB 1.1/ 2.0
maximum supply current	500 mA
file system	FAT16/ 32

Audio Section

maximum output power	50 W x 4
full bandwidth power	22 W x 4
speaker impedance	4 – 8 Ω
tone action band 1	60 – 200 Hz ±9 dB
tone action band 2	250 – 1k Hz ±9 dB
tone action band 3	1.25k – 4k Hz ±9 dB
tone action band 4	5k – 16k Hz ±9 dB
preout level / load	5000 mV/10 kΩ
preout impedance	≤ 80 Ω

Auxiliary Input

frequency response	20 Hz – 20 kHz
input maximum voltage	1200 mV
input impedance	100 kΩ

General

operating voltage	14.4 V
current consumption	10 A
installation size	182 x 53 x 155 mm
weight	3.31 lbs (1.5 kg)