Kenwood eXcelon KDC-X991 - Menu System - Firmware, Memory, and Demo Mode; Firmware Version Display; Internal Memory Format; Demonstration Mode Setting

English
|
53
In Internal Memory source
Internal Memory Format
Perform format to delete all audio files stored in
internal memory.
⁄
• The content of formatted memory cannot be restored.
Be careful when formatting.
1 Enter Internal Memory
Press the [SRC] button.
Select the "Internal Memory" display.
2 Enter Menu mode
Using the Control knob, select "MENU".
For the operation method, refer to <Function
Control mode> (page 11).
3 Select the Internal Memory Format
Turn the Control knob.
Select the "INT.MEM.Format" display.
4 Enter the Formatting mode
Press the Control knob for at least 1 second.
"Format?" is displayed.
5 Start format
Select "YES" using the Control knob.
"Format..." display blinks.
When the formatting finishes, "Completed" is
displayed.
6 Exit Formatting mode
Press the [FNC] button.
In Standby mode
Demonstration mode setting
Sets the demonstration mode.
1 Select the Demonstration mode
Turn the Control knob.
Select the "DEMO Mode" display.
2 Set the Demonstration mode
Press the Control knob for at least 2 seconds.
Each time you press the knob at least 2 seconds,
the Demonstration mode alternates between the
settings shown in the table below.
Display Setting
"DEMO Mode : ON" The Demonstration mode function is ON.
"DEMO Mode : OFF" Exit Demonstration mode (Normal mode).
In Standby mode
Firmware version display
Displaying the firmware version with the unit.
Turn the Control knob.
Select the "F/W Version : " display.
B64-3767-0000KEnglish.indd53B64-3767-0000KEnglish.indd53 07.5.102:16:07PM07.5.102:16:07PM