Features and Functions 4
Keysight 34970A/34972A User’s Guide 189
Remote Interface Configuration - 34970A
This section gives information on configuring the 34970A for remote interface
communication. For more information on configuring the instrument from the
front panel, see “To Configure the Remote Interface” starting on page 68. For
more information on the SCPI commands available to program the instrument
over the remote interface, see the Keysight 34970A/34972A Programmer’s
Reference Help.
GPIB address
Each device on the GPIB (IEEE-488) interface must have a unique address. You
can set the instrument’s address to any value between 0 and 30. The address is
set to “9” when the instrument is shipped from the factory. The GPIB address is
displayed at power-on.
You can set the GPIB address from the front panel only.
– The address is stored in non-volatile memory, and does not change when
power has been off, after a Factory Reset (*RST command), or after an
Instrument Preset (SYSTem:PRESet command).
– Your computer’s GPIB interface card has its own address. Be sure to avoid
using the computer’s address for any instrument on the interface bus.
Keysight’s GPIB interface cards generally use address “21”.
– Front-Panel Operation:
ADDRESS 09
To Next Page
Loading...
