2 Front-Panel Overview
60 Keysight 34970A/34972A User’s Guide
To Set a Scan Interval
You can set the instrument’s internal timer to automatically scan at a specific
interval (e.g., start a new scan sweep every 10 seconds) or when an external TTL
trigger pulse is received. You can configure the instrument to scan continuously or
to stop after sweeping through the scan list a specified number of times.
1 Select the interval scan mode.
For this example, select the Interval Scan mode which allows you to set the
time from the start of one scan sweep to the start of the next scan sweep. Set
the interval to any value between 0 and 99 hours
2 Select the scan count.
You can specify the number of times that the instrument will sweep through
the scan list (the default is continuous). When the specified number of sweeps
have occurred, the scan stops. Set the scan count to any number between 1
and 50,000 scans (or continuous).
INTERVAL SCAN
00020 SCANS
To Next Page
Loading...
