EasyManua.ls Logo

Keysight 34972A - Instrument Errors

Keysight 34972A
353 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5 Error Messages
238 Keysight 34970A/34972A User’s Guide
Instrument Errors
111 Channel list: slot number out of range
The specified slot number is invalid. The channel number has the form (@scc),
where s is the slot number (100, 200, or 300) and cc is the channel number.
Example: CONF:VOLT:DC (@404)
112 Channel list: channel number out of range
The specified channel number is invalid for the module in the selected slot. The
channel number has the form (@scc), where s is the slot number (100, 200, or
300) and cc is the channel number.
Example: ROUT:CLOSE (@134)
113 Channel list: empty scan list
Before you can initiate a scan, you must set up a scan list which includes all
configured multiplexer or digital channels in the instrument. Use the MEASure?,
CONFigure, or ROUTe:SCAN commands to set up your scan list.
201 Memory lost: stored state
This error is reported at power-on to indicate that a stored state has become
unusable. This error is most likely caused by a dead battery (memory is
battery-backed). Refer to the 34970A/34972A Service Guide to replace the
internal battery.
202 Memory lost: power-on state
This error is reported at power-on to indicate that the power-down state of the
instrument (normally recalled when power is turned on) has become unusable.
This error is most likely caused by a dead battery (memory is battery-backed).
Refer to the 34970A/34972A Service Guide to replace the internal battery.
203 Memory lost: stored readings
This error is reported at power-on to indicate that readings stored in memory
from a previous scan have been lost. This error is most likely caused by a dead
battery (memory is battery-backed). Refer to the 34970A/34972A Service Guide
to replace the internal battery.
204 Memory lost: time and date
This error is reported at power-on to indicate that the time and date settings
have been lost (they are reset to JAN 1, 1996 00:00:00). This error is most likely
caused by a dead battery (memory is battery-backed). Refer to the 34970A/
34972A Service Guide to replace the internal battery.

Table of Contents

Related product manuals