Error Messages 5
Keysight 34970A/34972A User’s Guide 251
Plug-In Module Errors
The following error messages indicate possible hardware failures within the
instrument. If any of the following errors occur, contact your nearest Keysight
Service Center for repair.
901 Mod ule hard ware: unexpected data received
902 Mod ule hard ware: missing stop bit
903 Mod ule hard ware: data overrun
904 Mod ule hard ware: protocol violation
905 Mod ule hard ware: early end of data
906 Mod ule hard ware: missing end of data
907 Module hard ware: module srq signal stuck low
908 Module hardware: not responding
910 Module reported an unknown module type
911 Module reported command buffer overflow
912 Module reported command syntax error
913 Module reported nonvolatile memory fault
914 Module reported temperature sensor fault
915 Mod ule reported firmware defect
916 Module reported incorrect firmware installed
To Next Page
Loading...
