5 Error Messages
244 Keysight 34970A/34972A User’s Guide
462
Configuration import aborted
Reconfiguration of the instrument was aborted.
463 Configuration import failed
This is a summary error that will be generated if ANY other errors were reported
during configuration import.
464 Invalid import file
The instrument did not recognize the USB configuration import file.
465 Import file cardset does not match instrument
The current instrument configuration does not match the cardset expected by
the USB import file.
466 Operation not allowed in a configuration import file
An illegal command was used inside the USB import file.
467 No readings to export
Reading memory is empty; nothing was exported to the USB drive.
468 Unable to fetch measurement config from internal processor
The instrument was unable to fetch measurement configuration data from the
secondary processor due to a communications error.
469 Internal processor returned an invalid measurement config
Configuration data returned by secondary processor was bad. Measurement
configuration could not be determined.
470 Measurement was reconfigured; Cannot save configuration data
Measurement configuration no longer agrees with the corresponding set of
readings. Configuration data will not be saved to the USB drive.
471 USB operation aborted; Cannot save configuration data
An abort or device clear was received while fetching configuration data from
secondary processor. Configuration data will not be saved to the USB drive.
472 One or more blcfg file names invalid; files inaccessible
Keysight BenchLink Data Logger BLCFG configuration files on the USB drive are
limited to 40 character filenames (including the .blcfg extension), and all
characters must be ANSI. Only legal filenames will be selectable for import.
473 Disk contains too many blcfg files; oldest files inaccessible
Instrument will only catalog the 50 most recently created Keysight BenchLink
Data Logger BLCFG files. Older files will not be selectable for import.
To Next Page
Loading...
