System Overview 3
Keysight 34970A/34972A User’s Guide 93
You can configure the event or action that controls the onset of each sweep
through the scan list (a sweep is one pass through the scan list):
– You can set the instrument’s internal timer to automatically scan at a specific
interval as shown below. You can also program a time delay between channels
in the scan list.
– You can manually control a scan by repeatedly pressing from the front
panel.
– You can start a scan by sending a software command from the remote
interface.
– You can start a scan when an external TTL trigger pulse is received.
– You can start a scan when an alarm condition is logged on the channel being
monitored.
Scan List (1 sweep)
Scan-to-Scan interval
(0 to 99:59:59 hours)
Scan Count
1 to 50,000 scans, or continuous)
t
To Next Page
Loading...
