2 53220A/53230A Software Installation and Interface Configuration
64 Keysight 53220A/53230A User’s Guide
Figure 2-6 Setting a VISA alias for the USB address string.
Disabling the USB interface
The USB interface can be disabled from the front panel by selecting I/O Config,
followed by USB Settings, and then USB Off. When disabling or enabling the USB
interface, you must cycle power for the change to take affect. When disabled, the
interface cannot be configured by the Connection Expert utility.
Using the USB interface with interactive IO
The Web-enabled instrument interface is not available from the USB interface.
An alternate programming method is to use the Connection Expert ‘Interactive IO’
utility (see “Using Interactive IO”).
To Next Page
Loading...
