Kidde VS Series User Manual

Appendix E: Releasing Module
P/N 3102351-EN • REV 005 • ISS 28DEC18 249
• Don’t configure Disable members using the User key for correlation groups with panel
events.
• Install a relay confirmation circuit to indicate when the release and prerelease circuits are
active.
• Don’t power the REL from the panel. You must power the REL using a compatible power
supply. See the GSA-REL Technical Reference Manual (P/N 387515-EN) for a list of
compatible power supplies.
REL fault messages
Table 55 below lists the messages you may see for the REL on the panel’s LCD.
Table 55: REL fault messages
Device
Condition LED LCD message
Monitor (Abort)
Short Monitor Monitor
Open Trouble Trouble
Abort [1]
Expanded message: Monitor Open
Pull (Manual)
Short Alarm Pull station
Manual [1]
Expanded message: Pull station
Open Trouble Trouble
Manual [1]
Expanded message: Pull station open
Supervised
Output
(Prerelease_1)
Short Trouble Trouble
Prerelease_1 [1]
Expanded message: Supervised output short
Open Trouble Trouble
Prerelease_1 [1]
Expanded message: Supervised output open
None
(Prerelease_2)
Short Trouble Trouble
Prerelease_2 [1]
Expanded message: Supervised output short
Open Trouble Trouble
Prerelease_2 [1]
Expanded message: Supervised output open

Kidde VS Series Specifications

General

Power Source	120V AC
Battery Backup	9V battery
Sensor Type	Photoelectric
Alarm Sound Level	85 dB at 10 feet
Hush Feature	Yes
Test Button	Yes
LED Indicator	Yes
Mounting Type	Wall or ceiling
Compliance	UL 217