Kobold VK200 - Cleaning the Kobold MR440 Mattress; Vacuumer; Additional Accessories

Maintenance99
4.5.3 CLEANING THE KOBOLD MR440
MATTRESS VACUUMER
Lavenia may get stuck between the rubber beater
bars of the Mattress Vacuumer.
1. Vacuum up the Lavenia residue with the Electric
Suction Hose, Flexo Nozzle or Soft Nozzle. Never
wet clean the entire device.
If it is very dirty, you can remove the beater unit from
the Mattress Vacuumer for separate wet cleaning:
1. Attach the Mattress Vacuumer to the Electric
Upholstery Brush
.
2. Remove the vibrating bars by first pulling one
side and then the other side of the holders out-
wards
.
3. Clean the vibrating bars under running water .
4.6 ADDITIONAL ACCESSORIES
This chapter applies to the following accessories:
– Kobold HD60 Hard Floor Nozzle
– Kobold VD15 Variable Nozzle
– Kobold FD15 Flexo Nozzle
– Kobold SD15 Soft Nozzle
1. The accessory heads can be rinsed off under
running water.
2. Allow the accessory heads to dry off before
reusing them.
3. Clean the bristles of the Soft Nozzle with soap
and lukewarm water.
3
1
2
4
2.
1
.
3.