3.4.8 AUTOMATIC APPLICATION OF
MOISTURE AND DRY MODE
The SP600 can moisten the cleaning cloth on three
different settings. In addition, you can activate a
one-off full saturation of the cloth by pressing a but-
ton, e.g. when you are just about to start cleaning.
NOTE
Material damage can occur when used on
unsuitable floors!
• For delicate floors, such as floors which are not
permanently sealed (oiled cork, oiled parquet,
coated, oiled stoneware), we recommend that
you first test the device in an inconspicuous
area to prevent damage to the floor.
• Please also refer to the cleaning and care infor-
mation issued by the floor manufacturer.
NOTE
Risk of damage from prolonged contact with
water!
• In the case of floors that are extremely sensitive
to moisture, wipe dry with a dry Kobold MF600
Parquet cleaning cloth and set the vacuum
cleaner to full power.
• If the floor is too wet, wipe with a dry MF600
Parquet or Dry cleaning cloth in dry mode.
Never dampen the cleaning cloth by hand.
Moisture may only be applied to the cleaning cloth
by the SP600.
Wash the cleaning cloth according to the
washing instructions before first use (see chapter
“Cleaning the Kobold MF600 cleaning cloths” on
page 69).
To Next Page
Loading...
