Operation44 45
3.2.4 WORKING IN KOBOSAN ACTIVE
1. Make sure that the dosage hopper is deactivated
.
2. Run the Carpet Freshener over the area covered
with Kobosan Active at right angles to the direc-
tion you were previously working in.
3. Massage the Kobosan Active in to the carpet for
up to three minutes per square metre, depending
on the degree of dirt, in all four directions.
4. Then open the windows and allow it to dry.
Depending on the type of carpet and the room
temperature, drying should not take longer than
30 minutes.
Once Kobosan Active has been worked in, you
no longer need the Carpet Freshener. The Carpet
Freshener should be cleaned immediately after
every use (see chapter “3.2.7 Cleaning the Kobold
VF200 Carpet Freshener after use” on page 45).
3.2.5 REPLACING THE ACCESSORY HEAD
1. Make sure that the Upright Vacuum Cleaner is
switched off and the mains plug is disconnected
from the socket.
2. Remove the Carpet Freshener from the Upright
Vacuum Cleaner (see chapter “2.4 Removing and
replacing the accessory head” on page 22) and
replace it with the Automatic Electric Brush.
To Next Page
Loading...
