Troubleshooting112 113
Fault Possible causes and rectification
The floor is getting too wet. • Set the SP600 to dry mode, as described in the
chapter “3.4.8 Automatic application of moisture
and dry mode” on page 61.
• Continue working without the automatic moistening
function for the time being until the floor appears to
be drying.
• Then
set the SP600 to moisture setting 1, as de-
scribed in the chapter “3.4.8 Automatic application
of moisture and dry mode” on page 61.
5.5 KOBOLD PB440 ELECTRIC UPHOLSTERY BRUSH
Fault Possible causes and rectification
The Electric Upholstery Brush
will not operate.
The Electric Upholstery Brush was connected to the
TR15 Telescopic Tube or a Suction Hose without the
power cord.
• Connect the Electric Upholstery Brush to an Electric
Suction Hose.
The Upright Vacuum Cleaner is not switched on.
• Switch on the device.
The bristles of the Electric
Upholstery Brush are deformed
or matted.
Fringes or fabrics were sucked in and pulled out again.
• Replace the suction nozzle.
The brushes of the Electric
Upholstery Brush no longer rotate.
The Upright Vacuum Cleaner is not switched on.
• Switch on the device.
The suction nozzle is not correctly inserted.
• Make sure to engage the suction nozzle properly.
Something was sucked in that is blocking the brushes.
• Switch the device off and unplug the mains plug
from the socket.
• Remove the object that was sucked in.
• Switch the device back on.
To Next Page
Loading...
