Operation52 53
3.4.4 ATTACHING THE KOBOLD SP600
The SP600 must first be attached to the Kobold vac-
uum cleaner:
1. Connect the attachment socket
of the vacuum
cleaner to the pivot on the SP600
.
2. Make sure you hear the attachment socket click
into the pivot.
3.4.5 SETTING AND RELEASING THE
STANDBY POSITION ON THE KOBOLD
SP600
The Kobold vacuum cleaner can be combined with
the Kobold SP600 in the usual way and either used
in the power setting or put into the standby position.
PUTTING THE DEVICE INTO THE STANDBY
POSITION
CAUTION
Risk of falling and causing injury!
The standby position is used to park the device
after you have finished working with it or when
you take a break.
• Ensure that the Kobold VK200 Upright Vacuum
Cleaner and Kobold SP600 are placed on a level
surface when put in the standby position.
• Never use the Kobold VK200 Upright Vacuum
Cleaner to support yourself.
• Never stand on the accessory heads.
NOTE
Risk of damage when the device starts up
automatically.
• Note that the vacuum cleaner and the Kobold
SP600 start up automatically when the vacuum
cleaner is taken out of the standby position if
you have not first switched off the vacuum
cleaner at the main switch.
1
2
1
2
click
To Next Page
Loading...
